35
Note: the battery is fully charged before delivery. However, storage and transportation
will inevitably cause some charge loss. Therefore, it is advisable to charge the battery for
12 hours before using it, so as to ensure adequate battery autonomy.
Caution: if the utility is abnormal, the UPS will transfer to battery mode.
(Line mode)
Indicator： on off
4.2 Start up
Turning on the UPS with AC
• Press "ON" button more than 1 second to start the UPS. During the UPS performing
self test, all the
Load/Battery capacity
LED indicators are lit and then turned off one
by one from right to left.
• Then
UPS is working in line mode, and the LED status is as follows.
• UPS supplies power to load.
Turning on the UPS without AC
• Press "ON" button more than 1 second to start the UPS. The UPS operations are the
same as in line mode.
To Next Page
Loading...
