Eaton Char-Lynn - Parts List

9
EATON Char-Lynn Delta Motors Parts and Repair Manual C-MOLO-TS003-E September 2007
Reassembly
CW
CW
CCW
CCW
B
A
B
A
Step 9
Install two greased seals into
the Geroler
®
. Install the
Geroler
®
onto the drive with
splined end away from the
housing. Align star according to
rotation preference as outlined
in the timing procedure. Timing
procedure is given below.
a. Standard Timing
Align the marked spline of the
drive with star tip. This pro-
duces CCW rotation when the
A port is pressurized.
b. Reverse Timing
Align the marked spline of the
drive with star valley. This pro-
duces CW rotation when the A
port is pressurized.
Hex Head
Screw
End Cap
Gerolor
Assembly
O-ring
O-ring
Timing
Mark
Timing
Mark
Standard Timing Reverse Timing
Step 10
Place the end cap on the
Geroler
®
and align the bolt
holes. Lubricate and insert
seven bolts and torque them to
500±50 lbf-in (42±4 lbf-ft, 56±5
Nm) in a crisscross pattern.
DeltaPartManual_v7.qxd:HydraulicsTech.qxd 9/19/07 11:40 AM Page 9