SPECIFICATIONS
3
POWER REQUIREMENTS:
AC Operation:
115/230 VAC (+10%, -20%) 47 - 63 Hz.
DC Operation:
11 - 28 VDC
Power:
18 Watts
DC POWER OUTPUT:
15 VDC (+1, -2).
150 mA if powered from AC or less than 24
VDC.
100 mA if powered from 24 VDC or greater.
NOTE: DC power output is only regulated if
unit is powered by AC or greater than 18.5
VDC.
ENVIRONMENT:
Operating Temperature:
32 to 130° F (0 to 55° C)
Storage Temperature:
-40 to 160° F (-40 to 70° C)
Operating Humidity:
85% non-condensing relative
PHYSICAL:
Case Dimensions:
5.38″ W × 2.62″ H × 5.91″ D
(136.7mm W x 66.5mm H x 150.1mm D)
Bezel Dimensions:
5.80″ W × 3.04″ H × 0.17″ 0
(147.3mm W × 77.2mm H × 4.3mm D)
LIP:
0.2″ (5.0mm)
Panel Cut-out Dimensions:
5.43″ W x 2.68″ H
(138mm W x 68mm H, DIN)
Mounting Panel Thickness:
0.58″ (14.7mm) maximum
(without optional spacer provided)
.077″ (1.96mm) maximum
(with optional spacer provided)
Front panel will provide watertight seal with
gasket provided.
Case Material:
Cadon FRX plastic case with Mylar front face
overlay
Weight:
2.2 lbs. (1.0 Kg)
Display Size:
6 digits, 0.56″ (14.2mm) H
(with programmable decimal point
location)
Memory Types:
PROM, RAM, Non-volatile NVRAM
COUNTER:
Count Range:
6 digits (0 to 999,999) with rollover
Preset Range:
6 digits (0 to 999,999) (3 presets)
Count Modes:
Count with Add and Subtract inputs
Count with Up/Down direction input
(Hardware doubling for above modes is
provided.)
Count with Count Inhibit input
Quadrature
Doubled Quadrature
Count Speed (Model 5886-0400):
0 to 7,500 CPS minimum for sensors with
open collector transistor output.
0 to 5,000 CPS when hardware doubling IS
implemented.
0 to 150 CPS when Low Frequency jumpers
are installed.
Count Speeds for Model 5886-1400 are shown
on page 28.
To Next Page
Loading...
