Eaton Durant Eclipse Series - Page 41

40
12345
1
234
5
1
234
5
1
234
5
1
234
5
1
234
5
12345
3. Press the
View
Enter
key,
Vi ew
En t er
PGM
Duran t
The flashing stops and count factor 2 is now the active count factor.
Changing a Preset Value
There are six possible presets, also known as setpoints, that can appear on the
display. No Eclipse uses more than four of them, and some or all of them may be
locked. If the operator attempts to change a preset value that is locked, the error
message
will appear on the display when the
Edi t
key is pressed. The title
screens for these presets are tot P, rat L, rat H, bat F, bat P, and CYC P. When the
View
Enter
key is released, the present preset value appears on the display.
To change the value of a preset or pulses per item (example - change preset 1 from
950 to 870):
1. Press the
Edi t
key,
Edi t
Durant
the left-most digit (MSD) begins to flash. The preset is edited one digit at a
time by selecting a digit (flash) and changing the value of that digit.
RUN MODE cont.
12345
1
234
5
1
234
5
1
234
5
1
234
5
12345
Indicates flashing digit.