44
2. Press the
View
Enter
key before the start prompt times out,
Vi ew
En t er
Duran
t
the display will show rESU (resume) for two seconds, and the indicating LED
will flash.
To terminate a batch that has been stopped, simply reset the batch counter with the
reset key.
Variations of starting and stopping are possible due to external inputs and program-
ming. However, the method described above should be fairly common.
If the Eclipse has been programmed to autorecycle; that is, to deliver a batch, then
wait for a timeout period and start another batch, the message will appear
briefly on the display each time a new batch is started. If the cycle setpoint is used to
stop delivery after a preset number of batches has been delivered, the message
will appear on the display after the number of batches is completed.
RUN MODE cont.
To Next Page
Loading...
