What to do if my Eaton Ellipse ECO 1600 operates on battery power when AC power is available?
The circuit breaker 13, located under the UPS, may have been tripped by an overload on the UPS output. Try resetting the circuit breaker.
What does it mean if the red LED 11 is on and the audio alarm beeps every 30 seconds on my Eaton Ellipse ECO 1600?
If the red LED 11 is on and the audio alarm beeps every 30 seconds on your Eaton UPS, it indicates a fault has occurred on the UPS and the battery backup outlets 9 are no longer supplied. Call after-sales support.
What does it mean if the red LED 11 is flashing on my Eaton UPS?
If the red LED 11 is flashing on your Eaton UPS, it means that the battery has reached the end of its service life. You should have the battery replaced.
What to do if green button 12 flashes and the audio alarm beeps continuously on my Eaton Ellipse ECO 1600?
If the green button 12 is flashing and the audio alarm is beeping continuously on your Eaton UPS, it indicates that the battery backup outlets 9 are overloaded. Disconnect some of the equipment connected to the battery backup outlets 9.
Why is the green button 12 flashing frequently and the audio alarm beeping on my Eaton Ellipse ECO 1600?
The green button 12 might be flashing frequently, and the audio alarm beeping because the Eaton UPS is frequently operating on battery power due to a poor-quality AC power source. To resolve this, have the electrical installation checked by a professional or try using another wall outlet.
Why is my Eaton Ellipse ECO 1600 UPS beeping and the green button 12 flashing frequently?
The AC power source may be of poor quality. Consult the power supply specifications.
What does it mean when the red LED 11 flashes on my Eaton Ellipse ECO 1600 UPS?
The battery has likely reached the end of its service life and needs to be replaced.
General| Power Rating | 1600 VA |
|---|---|
| Output Power Capacity | 1000 W |
| Output Voltage | 230V |
| Output Voltage Tolerance | +/- 10% |
| Number of Outlets | 8 |
| Communication Ports | USB, RS-232 |
| Humidity | 0-95% non-condensing |
| Warranty | 2 years |
| Topology | Line-interactive |
| Outlets Type | IEC C13 |
| Battery Type | Sealed lead-acid (SLA) |
| Efficiency | 95% |
| Frequency Range | 50/60 Hz |
| Operating Temperature | 0 to 40°C |
| Storage Temperature | -15 to +45°C |
| Typical Backup Time at 50% Load | 15 minutes |
| Typical Recharge Time | 4-6 hours to 90% |
Read safety instructions booklet (3) and this manual (2) before installation and heed warnings.
Illustrates connections for FR/DIN, IEC, USB models and network/modem options.
Covers UPS operation (On/Off) and warranty registration details.
Guidelines on battery service life reduction and safe disposal.
Step-by-step instructions for changing batteries in different Ellipse ECO models.
Details UPS power, voltage, frequency, current, and protection ratings.
Results of surge wave protection tests and dielectric isolation ratings.
Specifies suitable equipment for UPS and general operating conditions.
Details how to connect UPS, operate battery backup, and manage EcoControl outlets.
Common issues, diagnostics, and solutions for UPS operation.
Adjusting AC power sensitivity and audio alarm modes for the UPS.
To Next Page
