Why is my Eaton Ellipse PRO 650 running on battery when AC power is on?
If AC power is available but your Eaton UPS operates on battery power, the circuit breaker located at the rear of the UPS might have been tripped due to an overload. Try resetting the circuit breaker to restore normal operation.
What to do if the green button flashes on my Eaton Ellipse PRO 650?
If the green button on your Eaton UPS flashes and an audible alarm beeps every 3 seconds, it indicates that the battery backup outlets are overloaded. To resolve this, reduce the load on the battery backup outlets.
How to restore power to the battery backup outlets on my Eaton UPS?
If the battery backup outlets on your Eaton UPS are not supplied with power, ensure that the button is lighted. If it is not, press the button and check the outlets.
Why is the green LED off on my Eaton UPS?
If the green LED is off and the filtered outlets are supplied on your Eaton UPS, it means surge protection is no longer provided. Check the surge protector.
How to fix Eaton UPS EcoControl outlets staying on?
If the EcoControl outlets keep powered when the main application (Master outlet) is stopped on your Eaton UPS, it suggests that the EcoControl function is either not activated or not properly set. Activate or properly set the EcoControl function.
Why is my Eaton Ellipse PRO 650 operating on battery power when AC power is available?
If AC power is available but your Eaton UPS operates on battery power, it may be because the circuit breaker 20, located at the rear of the UPS, has been tripped by an overload on the UPS output.
How to fix Eaton UPS when battery backup outlets are not supplied with power?
If the battery backup outlets 19 on your Eaton UPS are not supplied with power, check if button 6 is lighted. If it is not, press button 6 to activate the outlets.
What does it mean when green LED 8 is off on my Eaton UPS?
If the green LED 8 is off and the filtered outlets 18 are supplied on your Eaton UPS, it means that surge protection is no longer provided.
Why do Eaton Ellipse PRO 650 UPS EcoControl outlets stay on when the master outlet is off?
If the EcoControl outlets on your Eaton UPS remain powered even when the main application (Master outlet) is stopped, it suggests that the EcoControl function is either not activated or not properly configured.
Read safety instructions booklet before installation and follow manual guidance.
Instructions for safely replacing the UPS battery for 650/850 and 1200/1600 models.
Connecting optional modem/network lines and USB for software control.
Adjusting EcoControl trigger thresholds via software for optimal peripheral management.
Steps for initial battery charging and turning the UPS unit on.
Method to shut down UPS battery backup outlets using the power button.
General| Power Capacity | 650 VA |
|---|---|
| Output Power | 400 W |
| Input Frequency | 50/60 Hz |
| Output Frequency | 50/60 Hz |
| Number of Outlets | 4 |
| Surge Protection | Yes |
| Topology | Line-interactive |
| Configuration | Tower |
| Output Outlets | 4 Schuko |
| Battery Type | Sealed Lead Acid |
| Typical Recharge Time | 4 hours |
| Communication Ports | USB |
| Operating Temperature | 0 to 40 °C |
| Storage Temperature | -15 to 45 °C |
| Relative Humidity | 0% to 95% (non-condensing) |
To Next Page