Why is the red LED on and the alarm beeping on my Eaton Ellipse MAX 600 UPS?
If the red LED on your Eaton UPS is on and the alarm beeps every 30 seconds, it means the battery backup outlets are overloaded. Disconnect some of the equipment connected to these outlets to resolve the issue.
How to stop the beeping and flashing green button on my Eaton Ellipse MAX 600 UPS?
If the green button on your Eaton UPS flashes frequently and the audio alarm beeps, it indicates that the UPS is frequently operating on battery power due to a poor AC power source. To solve this, have your electrical installation checked by a professional or try using a different wall outlet.
What does it mean when the red LED flashes on my Eaton Ellipse MAX 600?
If the red LED on your Eaton UPS flashes, it means the battery has reached the end of its service life. You will need to have the battery replaced.
Why is my Eaton UPS operating on battery when AC power is available?
If AC power is available but your Eaton UPS operates on battery power, it's likely that the circuit breaker located under the UPS has been tripped due to an overload. To fix this, disconnect some of the equipment plugged into the UPS and then reset the circuit breaker by pressing the corresponding button.
What to do if filtered outlets on my Eaton Ellipse MAX 600 UPS are not working?
If the filtered outlets on your Eaton UPS are not supplied with power, there could be two reasons. First, the wall outlet might not be receiving power, in which case you should ensure the wall outlet is properly supplied. Second, the circuit breaker located under the UPS might have been tripped by an overload. If this is the case, disconnect some equipment and reset the circuit breaker by pressing the button.
What to do if my devices aren't powered by my Eaton UPS during a power outage?
If your connected devices are not receiving power from the Eaton UPS during an AC power failure, make sure they are connected to the battery backup outlets.
How to fix Eaton Ellipse MAX 600 UPS battery backup outlets not working?
If the battery backup outlets on your Eaton UPS are not supplying power, press the power button and ensure that it turns green.
Why is my Eaton Ellipse MAX 600 disturbing the telephone line?
If you are experiencing telephone line disturbances or modem access issues with your Eaton UPS, it could be due to surge protection on the telephone line no longer being provided. Try disconnecting the telephone line from the wall outlet. If the issue persists, call after-sales support.
General| Nominal Output Voltage | 230 V |
|---|---|
| Nominal Input Voltage | 230 V |
| Output Voltage Options | 230 V |
| Surge Protection | Yes |
| Communication Ports | USB |
| Audible Alarm | Yes |
| Humidity | 0-95% non-condensing |
| Power Rating | 600 VA |
| Input Connection | IEC C14 |
| Battery Type | Sealed lead-acid (SLA) |
| Backup Time | Varies by load |
| Typical Backup Time at Full Load | 5 minutes |
| Operating Temperature | 0 to 40 °C |
| Storage Temperature | -15 to 45 °C |
| Certifications | IEC 62040 |
To Next Page