Why is my Eaton Ellipse ASR 450 UPS operating on battery when AC power is available?
If your Eaton UPS is running on battery power even when AC power is available, it's possible that the circuit breaker has been tripped due to an overload. To resolve this, disconnect some of the connected equipment to reduce the load and then reset the circuit breaker by pressing the corresponding button.
Why does my Eaton Ellipse ASR 450 UPS beep every second when the green button is on?
If the green button on your Eaton UPS is on and the alarm beeps every second, the battery has likely reached the end of its service life and needs to be replaced.
What to do if the filtered outlet on my Eaton UPS is not working?
If the filtered outlet on your Eaton UPS is not working, there could be two reasons: either the wall outlet itself is not receiving power, or the circuit breaker has been tripped due to an overload. First, ensure the wall outlet has power. If it does, disconnect some equipment to reduce the load and reset the circuit breaker by pressing its button.
What to do if Eaton Ellipse ASR 450 not supplying power to connected devices during outage?
If your devices aren't receiving power from the Eaton UPS during an AC power failure, ensure they are connected to the battery backup outlets.
How to fix Eaton Ellipse ASR 450 UPS battery backup outlets not working?
If the battery backup outlets on your Eaton UPS are not providing power, make sure that the button 8 is pressed and check that it turns green.
To Next Page
General