Why is my Eaton Ellipse PRO 1200 running on battery when AC power is on?
If AC power is available but your Eaton UPS operates on battery power, the circuit breaker located at the rear of the UPS might have been tripped due to an overload. Try resetting the circuit breaker to restore normal operation.
What to do if the green button flashes on my Eaton UPS?
If the green button on your Eaton UPS flashes and an audible alarm beeps every 3 seconds, it indicates that the battery backup outlets are overloaded. To resolve this, reduce the load on the battery backup outlets.
How to restore power to the battery backup outlets on my Eaton Ellipse PRO 1200?
If the battery backup outlets on your Eaton UPS are not supplied with power, ensure that the button is lighted. If it is not, press the button and check the outlets.
Why is the green LED off on my Eaton Ellipse PRO 1200 UPS?
If the green LED is off and the filtered outlets are supplied on your Eaton UPS, it means surge protection is no longer provided. Check the surge protector.
How to fix Eaton Ellipse PRO 1200 EcoControl outlets staying on?
If the EcoControl outlets keep powered when the main application (Master outlet) is stopped on your Eaton UPS, it suggests that the EcoControl function is either not activated or not properly set. Activate or properly set the EcoControl function.
Why is my Eaton UPS operating on battery power when AC power is available?
If AC power is available but your Eaton UPS operates on battery power, it may be because the circuit breaker 20, located at the rear of the UPS, has been tripped by an overload on the UPS output.
How to fix Eaton Ellipse PRO 1200 UPS when battery backup outlets are not supplied with power?
If the battery backup outlets 19 on your Eaton UPS are not supplied with power, check if button 6 is lighted. If it is not, press button 6 to activate the outlets.
What does it mean when green LED 8 is off on my Eaton Ellipse PRO 1200 UPS?
If the green LED 8 is off and the filtered outlets 18 are supplied on your Eaton UPS, it means that surge protection is no longer provided.
Why do Eaton Ellipse PRO 1200 UPS EcoControl outlets stay on when the master outlet is off?
If the EcoControl outlets on your Eaton UPS remain powered even when the main application (Master outlet) is stopped, it suggests that the EcoControl function is either not activated or not properly configured.
Read safety instructions booklet before installing and follow manual's instructions.
Safety warnings for battery replacement, disposal, and service life considerations.
Step-by-step instructions for replacing the battery in 650/850 models.
Step-by-step instructions for replacing the battery in 1200/1600 models.
Table listing common issues, diagnostics, and solutions for UPS operation.
General| Power Capacity | 1200 VA |
|---|---|
| Output Power | 720 W |
| Input Voltage | 230 V |
| Number of Outlets | 8 |
| Typical Backup Time (Full Load) | 5 minutes |
| Topology | Line-Interactive |
| Surge Protection | Yes |
| Data Line Protection | Yes |
| Efficiency | > 95% |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -15°C to 45°C |
| Relative Humidity | 0-95% non-condensing |
| Warranty | 2 years |
| Output Voltage | 230 V |
| Communication Ports | USB |
| Frequency Range | 50/60 Hz |
| Typical Recharge Time | 4-6 hours |
| Transfer Time | 4 ms |
To Next Page