To Next PageTo Next PageWhy is my Eaton Evolution 1550 overloaded?
If the Eaton UPS displays Button (10) and LEDs (13) and T (14) are ON and all the LEDs on the bargraph (8) flashing, it indicates that the percent load is exceeding the set overload level or the UPS capacity. To address this, verify the power consumption of the connected devices, disconnect any non-priority equipment, and review the overload level settings.
How to fix Eaton Evolution 1550 UPS battery fault?
If the Eaton UPS has LED (15) ON and all the LEDs on bargraph (11) are flashing, it indicates a battery fault detected during the automatic test. The suggested solution is to replace the battery module.
What to do if Eaton Evolution 1550 UPS button and LED are ON and LEDs on bargraph flash?
If the button and LEDs are ON and all the LEDs on the bargraph are flashing on your Eaton UPS, it means the percent load is greater than the set overload level or UPS capacity. To resolve this, check the power drawn by the connected devices and disconnect any non-priority devices. Also, check the overload level setting.
General| Type | Line Interactive |
|---|---|
| Nominal Input Voltage | 230 V |
| Form Factor | Tower |
| Humidity | 0-95% non-condensing |
| Warranty | 2 years |
| Model | Evolution 1550 |
| Power Rating | 1550 VA |
| Output Voltage | 230 V |
| Battery Type | Sealed Lead-Acid (SLA) |
| Typical Recharge Time | 4-6 hours to 90% |
| Operating Temperature | 0 to 40°C |
| Communication Ports | USB |
| Technology | Line Interactive |
| Topology | Line Interactive |
