Need help?Do you have a question about the Eaton Evolution S 3000 RT 3U and is the answer not in the manual?
General| Category | UPS |
|---|---|
| Model | Evolution S 3000 RT 3U |
| Power Rating | 3000 VA / 2700 W |
| Input Frequency | 50/60 Hz |
| Output Frequency | 50/60 Hz |
| Form Factor | 3U Rackmount |
| Operating Temperature | 0 to 40 °C |
| Input Voltage | 220-240 VAC |
| Output Voltage | 220-240 VAC |
| Battery Type | Sealed Lead Acid |
| Communication Interface | USB, RS232 |
| Outlets | (8) IEC C13, (1) IEC C19 |
EATON's environmental policy and eco-design approach for products.
Confirms product is free from CFCs, HCFCs, and asbestos.
Guidelines for separating and recycling packaging materials.
EATON's commitment to product recycling and disposal compliance.
Information on recyclable materials and disposal requirements.
Guidance on proper disposal of lead-acid batteries.
Explanation of graphical symbols used for instructions, advice, and signals.
Describes tower and rack mounting positions, dimensions, and weights.
Details connectors on rear panels for various Evolution and EXB models.
Overview of the UPS control panel elements and indicators.
Lists all UPS components and optional items included in the package.
Instructions for installing the UPS in an upright tower configuration.
Steps for mounting the UPS in a 19-inch rack using supplied rails.
Connecting RS232/USB ports and installing communication cards.
Procedure for connecting the UPS to a FlexPDU module.
Procedure for connecting the UPS to a HotSwap MBP module.
Explanation of the HotSwap MBP module's rotary switch and its functions.
Steps for direct UPS connection to power source and loads.
How to start the UPS and its behavior with AC power available.
How the UPS operates when AC power is lost, including alarms.
Indicates UPS shutdown due to depleted battery.
Automatic UPS restart upon AC power restoration.
Procedure for manually turning off the UPS.
Overview of RPO and ROO remote control features.
How to connect and test the remote control connector.
Configuring output voltage and overload alarm threshold.
Adjusting voltage thresholds for battery transfer and mode switching.
Setting the UPS sensitivity level to High or Low.
Configuring automatic start, cold start, and shutdown features.
Settings for battery tests, warnings, and deep discharge protection.
Diagnosing and resolving common UPS issues based on indicators.
Specific troubleshooting for UPS with HotSwap MBP module issues.
Safety precautions and step-by-step guide for replacing the battery.
Instructions for installing a new battery module in reverse order.
Procedures for maintaining UPS units with a HotSwap MBP module.
Information on EATON's technical training courses.
Detailed technical data for all Evolution UPS models.
Definitions of terms used throughout the manual.
To Next Page