12
Initial Start Up
Special Instructions
Before starting a vehicle always be seated in the driver’s seat, move the shift lever to
neutral, and set the parking brakes.
Before moving a vehicle, make sure you understand your shift pattern configuration. A
shift label should be in your vehicle’s cab. If not, refer to General Information section to
order.
Procedure
1. Make sure the shift lever is in neutral and the parking brakes are set.
2. Turn on the key switch, start the engine.
3. Allow the vehicle air pressure to build to the correct level. Refer to your “Operator
and Service Manual” supplied with the truck.
4. Apply the service brakes.
5. Make sure the range selection is in the Deep range position.
Range Lever MUST be in the Deep
Range position to start the
Operation
To Next Page
Loading...
