9
Optional Equipment:
By-pass System
When in downshift protection, the transmission will engage high range at the first
opportunity and will keep it in Hi range until the source of the failure is gone. By-pass
mode will allow the operator to drive the vehicle – only in low range – to a place where the
repair can be done. To turn on the by-pass system the driver must stop the vehicle, use the
parking brake and turn on the by-pass control (inside the vehicle cabin).
Shift Pattern Diagram
A shift pattern diagram should be in your vehicle. If it has been lost, a replacement may be
obtained by writing to:
Eaton Corporation
Truck Components
Rua Clark, 2061, Bairro Macuco – CEP 13279-400.
Valinhos - São Paulo - Brasil.
Phone: 0800-170551.
Please specify shifting controls used and transmission model number when making request.
General Information
To Next Page
Loading...
