21
Service and Maintenance
5. Lubricant
• Change at specified service intervals.
• Use only the types and grades recommended.
6. Filler and Drain Plugs
• Remove filler plugs and check level of lubricant at specified
intervals. Tighten filler and drain plugs securely.
7. Capscrews and Gaskets
• Check all capscrews, especially those on P.T.O. covers and rear
bearing covers for looseness which would cause oil leakage.
• Check P.T.O. opening and rear bearing covers for oil leakage due
to faulty gasket.
8. Shift Lever
• Check for looseness and free play in housing. If lever is loose in
housing, proceed with check number 9.
9. Shift Lever Housing Assembly
• Remove air lines at slave valve and remove the shift lever hous-
ing assembly from transmission.
• Check tension spring and washer for set and wear.
• Check the shift lever spade pin and slot for wear.
• Check bottom end of shift lever for wear and check slot yokes
and blocks in shift bar housing for wear at contact points with
shift lever.
To Next Page
Loading...
