Load Custom Configuration, FC 351
The Load Custom Configuration function loads all of the set-
tings and configuration data from the file labeled with the
file format "regulator ID-reading #.CFG".
EXAMPLE : 12345-001.CFG
After inserting a CF card, access FC 351. Press Enter. The
control LCD will display (CONFIRM). Press Enter again to
confirm. The Flash Card Active LED will illuminate, the
LCD will display (LOADING...), and the control will load the
configuration data from the CF card. Upon completion, the
control will display (LOADING COMPLETE). The CF card
may be removed after this message is displayed.
If the command is completed with errors, a (LOADING
FAILED) message is displayed on the fourth line of the LCD.
If the command is in progress and is aborted via the ESC
key, a (LOADING ABORTED) message is displayed on the
fourth line of the LCD.
Format Compact Flash Card, FC 355
The Format Compact Flash Card function effectively erases
all data on a CF card and prepares the card for use in the
CL-6 series control. A card that has not been formatted for
use on the CL-6 control may not work on the control (i.e.,
cards used to store digital photos, etc.)
After inserting a CF card, access FC 355. Press Enter. The
control LCD will display (CONFIRM). Press Enter again to
confirm. The Flash Card Active LED will illuminate, the
LCD will display (FORMATTING...), and the control will
format the CF card. Upon completion, the control will
display (FORMATTING COMPLETE). The CF card may be
removed after this message is displayed.
If the command is completed with errors, a (FORMATTING
FAILED) message is displayed on the fourth line of the LCD.
If the command is in progress and is aborted via the ESC
key, a (FORMATTING ABORTED) message is displayed on
the fourth line of the LCD.
Other compact flash card functions
There are several other Compact Flash Card Functions
available using FC 357 through FC 368. Each of the
functions allows for saving or loading subsets of control and
communications settings either as standard or custom
operations. The load and save functions along with the
standard and custom configurations have the same meaning
as described for FC 351 through 354.
FC 357 through FC 360 apply to the loading and saving of
standard and custom Basic Configuration settings. Basic
Configuration settings include all basic voltage regulation
settings entered using the control key pad except for
communications settings.
FC 361 through FC 364 apply to the loading and saving of
standard and custom Advanced Feature Configuration
settings. Advanced Feature Configuration settings include
settings for Histograms, Alarm and Event Recorders, Profile
Data, Programmable I/O and Leader/Follower.
FC 365 through FC 368 apply to loading and saving of
standard and custom Communication Configuration
settings. Communication configuration settings include all
settings involving communications. A list of these settings
can be found in Table 5-2 under *Features/
*Communications.
See the list of functions in Table 5-3.
94
CL-6 SERIES CONTROL INSTALLATION, OPERATION, AND MAINTENANCE INSTRUCTIONS MN225016EN January 2016
To Next Page
Loading...
Need help?
General
