6 Installation Instructions MN915001EN June 2016
GridAdvisor Series II smart sensor
LED installation indication
The LEDs provided on the GridAdvisor Series II smart
sensor provide annunciation during the installation of device
to verify proper load current is present.
Table 2. GridAdvisor Series II Smart Sensor LEDs Provided
Sequence Step (in order) Source LED Load LED
Current present below 10 Amps RED Moving Bar Sequence for Direction RED Moving Bar Sequence for Direction
Current present below 50 Amps AMBER Moving Bar Sequence for Direction AMBER Moving Bar Sequence for Direction
Current present above 50 Amps Green Moving Bar Sequence for Direction Green Moving Bar Sequence for Direction
Programming sensor
Please refer to Programming Guide S1150-20-2 for
instructions on connecting to sensor with Bluetooth
®
module and/or programming device with ProView NXG
software.
Support
Eaton is proud to offer a comprehensive collection of
support resources for users requiring additional information
or assistance in the setup, operation, and troubleshooting
of GridAdvisor Series II smart sensor and other equipment
from Eaton.
For technical support, contact EAS Support at 800-815-2258
or EAS-Support@Eaton.com, or contact your local Eaton
representative.
To Next Page
Loading...
