Eaton i-on30EX - Preventing any Remote from Unsetting the System

4. Administration i-on40 & i-onEX Range
Page 100
Preventing Any Remote From Unsetting the
System
You may wish to prevent any remote from unsetting your alarm system.
You can do this as follows:
1. Make sure the display shows the
standby screen.


2. Press .


3. Key in your access code (or
present a tag).


4. Press  until you see:.


5. Press .


6. Press  until the display shows:


7. Press .


8. Press  until the display shows:


9. Press .
The display shows:


10. Press . or  until the display
shows:


11. Press 
The keypad gives a double “beep”
confirmation tone. The keypad
display shows:


12. Press  repeatedly to leave the
menu.
Once you have carried out this process, then although remote controls can
set the system, none of them can unset the system. To allow remote
controls to unset the system repeat steps 1 to 12, but select “enabled” at
step 10.