Eaton i-on30EX - Unsetting the System via Keypad

i-on40 & i-onEX Range 3. Setting and Unsetting
Page 29
Override by:
Message
Meaning
Grade 2
Grade 3

A Hold Up Alarm device is
still active. (If a user has
forgotten to reset the device
an installer is not required.)
Installer
Installer

A part of the system has
been tampered with.
Installer
Installer

An expander or keypad has
a fault, or the cabling
between parts of the system
has a fault.
Installer
Installer

The AC supply has stopped
for more than 10 seconds.
User
User

The back-up battery has a
problem.
User or
Installer
Installer

or

Part of the communication
system has a problem.
User or
Installer
Installer

The system has
detected a fault not covered
by the above categories.
User
User
Unsetting the System Using a Keypad
When unsetting the system do not stray from the entry route designated by
the installer. If you do so then you will cause an alarm.