Eaton i-on30EX - Page 69

i-on40 & i-onEX Range 4. Administration
Page 63
9. Press . to see the first of the walk
test options:


The Walk Test menu provides three options to give different ways of
organising a walk test. The options within Walk Test are:
System
This option allows you to walk round the entire system and
test all the zones. Press  to select this option.
Partitions
(Only in partitioned systems.) Use this option to select one
or more partitions, and test the zones only within those
partitions.
Press  or  to scroll up and down the list of partitions.
Press  or  to display “Yes” at the end of the bottom line
to mark the partition as one you want to test. Press  when
you have finished making your selection.
Zones
This option lets you select one or more individual zones,
and test only those zones and no others.
Press  or  to scroll up and down the list of zones. Press
 or  to display “Yes” at the end of the bottom line to
mark the zone as one you want to test. Press  when you
have finished making your selection.
Once you have selected the Walk Test option you want to use:
The top line of the display shows
you how many detectors remain to
be tested. The bottom line of the
display shows a list of all the
detectors ready for testing.


10. Walk round and trigger each
detector. The display shows an "A"
at the end of the line each time a
detector is triggered. If you have
enabled the Chime then every time
you trigger a detector the keypads
and loudspeakers give a double
tone chime.
Note that you cannot test HUA, 24
hour or fire zones.

