Eaton i-on30EX - Page 96

4. Administration i-on40 & i-onEX Range
Page 90
7. Press .


8. Press .


9. EITHER
Press the button on the remote
control that you wish to program.
Hold the button down until you
see the transmit LED flash.
Only the “*” button (Part set) is
available on a FOB-2W-4B.
The keypad gives a double
“beep” confirmation tone. The
display shows the identity and
owner of the remote control, and
the button you pressed. Go on to
step 10.
Note: If your system is a part setting
system (there are no partitions)
then you cannot reprogram the
unset key on a remote control.
If your system is a partitioned
system then the unset button
can only be programmed to
unset all partitions allocated to
the user, or unset individual
partitions allocated to the user.


OR (if you do not have the remote in
your possession)
a) Press .
The display presents a list of the
registered remote controls and
their users.


b) Press  or  to show the
remote control you want to edit.

