Eaton PowerXL DM1 Series - Standard application-parameters list

31
Step 5 - Standard application
POWERXL DM1 SERIES ADJUSTABLE FREQUENCY DRIVES PUB53696—August 2020 www.eaton.com
Standard application—parameters list
On the next pages you will find the lists of parameters
within the respective parameter groups. Each parameter
section within the table lists:
•
Parameter code (location indication on the keypad;
shows the operator the present parameter number);.
•
Parameter name;
•
ID (number of the parameter);
and where applicable:
•
Minimum value and units;
•
Maximum value and units;
•
Default value and units;
•
Options (when available); and
•
Description of the parameter.
Table 8. Monitor (Cont.).
M1 - standard.
M1.1
Output frequency
ID 1
Minimum value:
Hz
Maximum value:
Hz
Default value:
Hz
Description:
Output frequency (Hz).
M1.2
Frequency reference
ID 24
Minimum value:
Hz
Maximum value:
Hz
Default value:
Hz
Description:
Reference frequency (Hz).
M1.3
Motor speed
ID 2
Minimum value:
rpm
Maximum value:
rpm
Default value:
rpm
Description:
Motor output speed (rpm).
M1.4
Motor current
ID 3
Minimum value:
A
Maximum value:
A
Default value:
A
Description:
Motor output current RMS (Amps).
M1.5
Motor torque
ID 4
Minimum value:
%
Maximum value:
%
Default value:
%
Description:
Percent motor torque calculated from nameplate values and measured motor current (%).
M1.6
Motor power
ID 5
Minimum value:
%
Maximum value:
%
Default value:
%
Description:
Percent motor power calculated from nameplate values and measured motor current (%).
M1.7
Motor voltage
ID 6
Minimum value:
V
Maximum value:
V
Default value:
V
Description:
Output ac motor voltage (Vac).
M1.8
DC-link voltage
ID 7
Minimum value:
V
Maximum value:
V
Default value:
V
Description:
DC bus voltage (Vdc).
M1.9
Unit temperature
ID 8
Minimum value:
°C
Maximum value:
°C
Default value:
°C
Description:
Heat sink temperature (deg C).
.