Need help?Do you have a question about the Eaton PowerXL Series and is the answer not in the manual?
General| Control Method | Vector Control, V/f Control |
|---|---|
| Operating Temperature | -10°C to +50°C |
| Enclosure | IP20 |
| Communication Protocols | Modbus |
| Protection Features | Overcurrent, overvoltage, undervoltage, short circuit, over temperature |
Crucial steps before starting installation, including power disconnection and personnel safety.
Alerts regarding dangerous electrical voltage and capacitor discharge.
Covers grounding, qualified personnel, electrostatic discharge, and cable installation.
Instructions for inserting and removing option boards from the control board slots.
Guidance on connecting the drive to the Ethernet network using CAT-5e cables.
Parameters that can be set on keypad for the SmartWire-DT module.
Configuration of static IP addresses and enabling BACnet/IP.
Using the keypad for Ethernet communication setup, including DHCP.
Steps to manually configure static IP addresses for Ethernet devices.
Steps for connecting and preparing the RJ45 port for BACnet/IP communication.
Guide to manually configuring IP addresses using the drive keypad.
Information on basic diagnostic alarms and collective diagnostics.
Details on advanced diagnostic messages provided by the drive.
To Next Page