166
Commissioning
POWERXL SERIES VFD MN040010EN—June 2018 www.eaton.com
Commissioning
Connections and wiring
The RJ45 port supports 10/100 Mb speeds in both full and
half-duplex modes. The boards must be connected to the
RJ45 network with a shielded CAT-5e cable. A crossover
cable (at least CAT-5e cable with STP, shielded twisted pair)
may be needed if you want to connect the drive directly to
the master appliance.
Use only industrial standard components in the network and
avoid complex structures to minimize the length of response
time and the amount of incorrect dispatches.
It is often a good practice to use a subnet that is different
from other devices not related to the drive control.
Figure 70. CAT-5e cable
To Next Page
Loading...
