Eaton PowerXL Series - Figure 55. Smartwire-DT DXG-NET-SWD-IP20 Module Details; Figure 56. Smartwire-DT DXG-NET-SWD-IP54 Module Details; Hardware Specifications; Smartwire-DT

148
SmartWire-DT External Communication Cards
POWERXL SERIES VFD MN040010EN—June 2018 www.eaton.com
Hardware specifications
PowerXL DG1 Series has two SmartWire-DT communication
modules, “DXG-NET-SWD-IP20” for IP20 and
“DXG-NET-SWD-IP54” for IP54
Figure 55. SmartWire-DT “DXG-NET-SWD-IP20”
module details
Figure 56. SmartWire-DT “DXG-NET-SWD-IP54”
module details
The following drawing shows the DXG-NET-SWD-IP54
SmartWire-DT Communication Module
LEDs
SmartWire-DT LEDs are as stated below
Table 182. SmartWire-DT Diagnostic LED
Color Status Meaning
Green LED flashes slowly (1Hz). Device is active, but it is not coupled to the SWD bus.
Green LED flashes quickly (3Hz). An error condition was discovered. Device may or may not be
in normal operation.
Green LED is turned on
continuously.
Device is in normal operation
1. Connection of SmartWire-DT
external device plug
2. SmartWire-DT dignostics LED
3. Modbus cable
4. Mounting screw
5. Selection DIP Switch
1. Connection of SmartWire-DT external
device plug out
2. Connection of SmartWire-DT external
device plug in
3. SmartWire-DT dignostics LED
4. Modbus cable
5. Mounting screw