Eaton PowerXL Series - Figure 50. Trunk Lines or Drop Lines; Figure 51. Devicenet Hardware

122
DeviceNet cabling
POWERXL SERIES VFD MN040010EN—June 2018 www.eaton.com
DeviceNet cabling
When using DeviceNet, it uses a basic trunk-line/drop-line
topology with separate twisted pair busses for both signal
and power distribution. Wire diameter for the trunk and
drop lines may vary, and the distance will be determined
by baud rate and cable size. In this topology, devices are
powered directly from the bus and communicate with each
other using the same cable. Nodes can also be removed or
inserted into the network without powering it down.
Figure 50. Trunk lines or drop lines
Hardware speci cation
Figure 51. DeviceNet hardware
DeviceNet External Communication Cards has termination
switch S1. It should not be used in network and kept at
OFFposition.