169
Commissioning
POWERXL SERIES VFD MN040010EN—June 2018 www.eaton.com
Manual IP address configuration
Using the PowerXL DH1 drive keypad
Using the Drive Keypad to set the IP Address manually in the device.
1. Select IP addressing mode as Static IP. Static IP
mode configurations will be loaded.
ote: N Change in IP address mode will require drive to
power cycle to get this change effective. Also ensure
device MAC address.
2. Using the drive keypad, set the IP address in
the device to the desired address setting by.
a. Setting Static IP Address
b. Setting Static Subnet Mask
c. Setting Static Default Gateway
Figure 72. DH1 Static IP mode
3+
3+
!"#$
%&#
'(
3+
) *% #+
'(
)'($
3+
) *% #+
.4!3
.(%12
.(%2
3(
12
) *% #+ )
) *% #+
!"#$
3+
) *% #+
.453
.4!3
.3(%12
%&#!3
3+
) *% #+
.4.3(
.4./0)'
!"#$
3+
) *% #+
.4..-03'
.4..///
.4..(61//
!"$#
3+ 1)
) *% #+
.4..
1///
%7'&!1
!"##
3+ 1)
) *% #+
.4..
1///
%7'&!1
!"##
3+ 1)
) *% #+
.4..
1///
(
2#
##(
To Next Page
Loading...
