Eaton PRC-E Series - Page 74

70
Web page programming
PRC-E Series Instruction Manual MN014003EN August 2015 www.eaton.com
Digital switch configuration
Pow-R-Command Digital Switches (DS) are programmable
devices that communicate over the proprietary Digital
Switch Network (DSN) that is included on the PRC1000E,
PRC1500E and PRC2000E. The DS is available in 2-, 4-, and
6-button configurations. Each has onboard I/O to receive
inputs from occupancy sensor and/or photo sensors, and an
analog output to control 0–10 V dimmable ballasts and LED
drivers. This dimming could be closed loop or step dimming
using a button-activated control scheme. See the “Digital
Switch” section on page 81 for more information.
The “Devices” screen displays a list to the digital switch
network devices connected to the host controller.
Click the “Devices” tab.
This opens the devices Web page.
ote:N Each PRC digital switches must be given a unique
address number of 1 to 99 using the rotary switches
on each. See the “PRC Digital Switch” section of this
document (see page 81).
On this left of this screen, a table is displayed with the
PRC digital switch devices that are connected to the DSN
network and their basic attributes.
ote:N If a Digital Switch does not show in the table,
right-click the address line of the DS and choose
“Refresh” in the context menu. This should repeat
the search for the Digital Switch.
The number in the “#” column contains the unique Digital
Switch address. The address range is from 1 to 99.
The switch “Description” column is an editable 20-character
alphanumeric description that could describe the area
controlled or purpose of the switch.
The “Version” column contains the firmware version of the
PRC Digital Switch.
The “Type” column contains the number of buttons on the
switch. The types available are 2-button (DSN 2-B), 4-button
(DSN 4-B) and 6-button (DSN 6-B).
ote:N If a red “X” appears beside the number field, this
indicates that no switch was found during a search.
To program the PRC Digital Switch, click the digital switch
line in the table to be programmed.
This should display a tabular PRC Digital Switch status/
configuration page in the right pane.
The DSN status should be the default tab.
Click the “DSN Status” tab, if needed.
ote:N If any programming edits are made, accept pending
changes before choosing another tab.