Eaton PRC-E Series - Page 77

73
Web page programming
PRC-E Series Instruction Manual MN014003EN August 2015 www.eaton.com
Setting the analog point “Action”
Click the analog “Action” dropdown arrow next to the button
to be programmed.
This opens the dropdown list for a quick pick of the
actions available.
Click to select the required action.
None: No analog point action commanded.
Set: The analog point chosen will be set to the setting in the
“Value” input box.
Inc: Increment; the analog point chosen will be incremented
by the setting in the “Value” input box.
Dec: Decrement; the analog point chosen will be
decremented by the setting in the “Value” input box.
Setting the analog point adjustment “Value”
Click the “Value” input box of the button to be programmed.
This opens the input box for edit.
Input the required numeric value for the analog adjustment
using the keyboard. Remember, this value will be used by
the analog action to adjust the selected analog point. This
will be the set value of the analog output or the setpoint of
the closed-loop feedback from the photocell.
The “Feedback Point” controls the indicator LED of each
button. An active button command can illuminate the LED of
that button. This point can be a circuit breaker, flag, analog
point (value), etc.
“Default” is checked by default. With this active, the digital
switch feedback point textbox is inaccessible. The default
point will be set as follows:
Digital point: If the digital point action is set and there is
no analog setup, the button will illuminate when the digital
point is ON.
“LIGHT_LVL”: If the “LIGHT_LVL” point is selected and the
“Set” analog action is selected, the button will illuminate
when the digital switch analog output is equal to the set
value.
If any other analog actions are selected, the default will
be blank.
To edit the default feedback indication point, uncheck the
default box.
Click the “Feedback Point” dropdown arrow next to the
textbox of the button to be programmed.
This opens the dropdown list for a quick pick of some
common points.
If the point required is not in the list, the textbox can be
edited using the keyboard to enter the address.
To edit the “Feedback” textbox, click the “Feedback Point”
textbox of the button to be programmed.
This opens the textbox for editing.