Eaton XN300 - Page 112

17 Digital output module XN-322-16DO-P05
17.1 Pin assignment and status LED signals
XN300 slice modules 02/24 MN050002EN Eaton.com 108
Table 6 Status LED signals
Module status
Green ON System OK
OFF No power
FLASHES (5 Hz) No communications
Status User yellow ON The user can set the LED signals as necessary.
(For example, the visualization interface can be used to
set the module's LED to flash so that it is easier to find
the module inside the control panel.)
OFF
FLASH
(200 ms ON,
1000 ms OFF)
FLASH
(1000 ms ON,
200 ms OFF)
Status of output n
n = 1 to 16
yellow ON Output is "ON"
OFF Output is "OFF"
Power status of
group n
n=1to2
Green ON Group n is being powered with 24 VDC
OFF Group n is not being powered properly (undervoltage) or
the system is not being powered at all. If the system is
not being powered at all, the module status LED will be
OFF.