0 About this manual
0.2 Additional Documentation
13 XN300 slice modules 02/24 MN050002EN Eaton.com
0.2 Additional Documentation
Please follow the safety instructions in the "Product Cyber Security Guideline
for XN300 Slice Modules", MZ050024EN and observe "End User License
Agreement XN300 Slice Modules“, MZ050025EN.
0.3 Target group
This manual is intended for automation technicians and engineers.
Extensive knowledge of how to work with the field bus being used will make
it easier to understand the contents of this manual.
A specialist knowledge of electrical engineering is needed for commissioning
and programming.
0.4 Legal disclaimer
All information in this operator manual was provided by us to the best of our
knowledge and belief and in accordance with the current state-of-the-art.
However, this does not exclude the possibility of inaccuracies so that we
cannot accept any liability for the accuracy and completeness of the informa-
tion. In particular, this information does not guarantee any particular proper-
ties.
The devices described here must only be set up and operated as specified in
this manual and in the installation instructions provided with the device.
Installation, commissioning, operation, maintenance and refitting of the
devices must only be carried out by qualified persons. The devices must only
be used in the areas recommended and only in conjunction with third-party
devices and components that have been approved by us. Only use is techni-
cally faultless condition is permitted. Fault-free and safe operation of the sys-
tem requires proper transport, storage, installation and commissioning as
well as careful operation and maintenance. If the following safety instruc-
tions are not observed, particularly with regard to commissioning and mainte-
nance of the devices by insufficiently qualified personnel and/or in the event
of improper use of the devices, any hazards caused by the devices cannot be
excluded. We assume no liability for any injury or damages incurred.
To Next Page
Loading...
