Eaton XN300 - 2.4 Connecting the power supply

2 Installation
2.1 Mounting the XN300 slice modules
21 XN300 slice modules 02/24 MN050002EN Eaton.com
 Repeat these steps until all the XN300 slice modules form a system
block together with the gateway.
 Pull the locking elements at the back of the gateway and the XN300 slice
modules upwards. You can use a screwdriver to do this.
Figure 4: Securing the system block on the DIN-rail
 Tilt the system block forward and place it against the DIN-rail's bottom
edge in an inclined position.
Figure 5: Placing the system block against the bottom edge of the DIN-rail
 Push the system block over the DIN-rail's top edge.
 Push the locking elements on the back of all XN300 slice modules
downwards in order to secure the modules. You can use a screwdriver
to do this.

Figure 6: Locking the system block into place on the DIN-rail
 Check to make sure that the system block is solidly mounted.
4
6
5
7