Eaton XN300 - Page 26

2 Installation
2.2 Removing the XN300 slice modules
XN300 slice modules 02/24 MN050002EN Eaton.com 22
2.2 Removing the XN300 slice modules
To remove the XN300 slice modules, follow the steps below:
 Slide the locking elements on the back of all XN300 slice modules
upwards. You can use a screwdriver to do this.

Figure 7: Disengaging the system block
 Tilt the system block forward, then pull the block, from its bottom edge,
away from the DIN-rail.
Figure 8: Placing the system block against the bottom edge of the DIN-rail
1
2
3