EBA 550 - Working with Programs; General; Escape the Program Mode; Cutting Counter

- 24 -
EBA 550 • EBA 550 LT
Working with programs
• Press
p
 "X" appears on the display
•
0 1
...
9 9
Enter program number 01 ... 99
With the button
j
and
b
you are able to
change between several program steps.
With
S
the backgauge moves to the indicated
dimension.
With
s
the backgauge stops.
General
LED "S" lights  Cut is blocked.
LED "S" is off  the actual dimension appears.
In the program mode the ejection of paper
j
is not possible. The ejection of paper has to
be programmed.
Escape the program mode
• Press
p
 "X" appears on the display.
• Press
s
 escape the program mode.
Cutting counter
• Press
i
and hold and press
0
.
 number of cuts are shown.
Press
c
twice to delete the number of cuts.
Press
s
to escape the cutting counter.
• Operation •