EBA 550 - Eject Function; Adjust the Eject-Dimension; Display in CM or Inch; Cutting Activation

- 20 -
EBA 550 • EBA 550 LT
Eject function
If button
j O
is pressed instead of button
S
Q
, after inserting the measurement
S
, the
backgauge will advance forwards so that
paper can be removed. Finally the backgauge
moves to the last setting.
Adjust the eject-dimension
• Press
p
, hold, and press
T

e
on
display.
• Insert the desired dimension
(Standard is 20 cm).
•
g
Store dimension.
•
p
+
s
Escape the program mode.
Program buttons
b
and
j
programs
Press
p
, hold, and press
b
(
ö
appears
on the display) or
Press
p
, hold, and press
j
(
Ü
appears
on the display)
• Enter the desired dimension (For example:
29,7 cm x 21 cm can be entered for DIN A4)
•
g
Store dimension.
Display in cm or inch
• Press
i
 display changes between cm
and inch.
Cutting activation
Warning!
• Run backgauge to the front for turning the
paper stack.
• Do not interrupt the upward movement of
the blade by performing switching
procedures.
• Release blade only when LED "S" has gone
out.
• Close the front safety guard
A
.
• Blade must always be at the top and be
covered by the clamp. Do not touch the blade.
Risk of injury!
• Press both buttons of the two-handed
control system simultaneously and keep them
pressed until the paper is completely cut.
• Operation •