VEHICLE HEATERS – TECHNICAL DOCUMENTATION | 13
CHANGE THE TEMPERATURE SETPOINT AND / OR
THE OPERATING TIME DURING OPERATION
Press the
or button to activate the mobile
unit. Following successful data transmission the
HEATING / VENTILATION / ADD-ON UNIT HEATING or
ADD-ON UNIT VENTILATION menu item is displayed.
Press the SHORTPRESS button for less than
2 seconds.
PLEASE NOTE!
The temperature setpoint set before switching on the
heater or confirmed temperature setpoint and the
current remaining operating time are displayed as
set values.
The operating time and the temperature setpoint are
changed once.
Both set values must be confirmed.
SET TEMPERATURE SETPOINT – ONLY FOR AIR HEAT-
ERS, NOT FOR THE VENTILATION FUNCTION
If applicable, use the
or button to set the
temperature setpoint.
Temperature setpoint setting range:
8 °C – 36 °C in 1 °C increments,
46 °F – 97 °F in 1 °F increments.
21 °C
Press the button to confirm the temperature set-
point. The temperature setpoint is changed once.
3 OPERATION AND SETTING/ADJUSTMENT
HEATING OFF WITH SHORTPRESS
Press the
or button to activate the mobile
unit. Following successful data transmission the
HEATING menu item is displayed.
Press the
SHORTPRESS button for less than
2 seconds.
Heater OFF.
The display lighting goes out 10 seconds after
HEATING OFF is displayed.
PLEASE NOTE!
The heater switches off, an active add-on unit
remains in operation.
The following actions are possible during the
HEATING OFF display:
Use the
or button to select a menu item.
SHORTPRESS button; the Start display appears.
SHORTPRESS button; the HEATING submenu is
displayed.
To Next Page
Loading...