VEHICLE HEATERS – TECHNICAL DOCUMENTATION | 5
1 INTRODUCTION
GENERAL INFORMATION
The mobile unit of the EasyStart Remote
+
radio
remote control has a simple control structure.
All functions can be set and, if necessary, changed
with only 4 buttons.
The pulses of the mobile unit have a range of up
to 1000 metres outdoors (direct visual contact).
External interference, local conditions and high
building density in the surrounding area shorten
the range.
The mobile unit should always be pointed towards
the vehicle when activated or for data transmis-
sion.
Depending on the use and ambient effects, how-
ever, displays can appear on the display, which are
described in the chapter “What to do if …?”
from page 31.
If you and the mobile unit are outside the range
you do not have to do without the heater. The pre-
set mode is then available as an alternative.
If a vehicle was powerless (battery disconnected)
and the power supply is restored, the button
flashes for 30 seconds and Add or AddE appears
in the display for selection. Press the button
to confirm the selection.
The time and the weekday must then be set.
Use of the mobile unit is described in detail
from page 7.
NOTE ON THE AddE DISPLAY
The AddE function is used to only teach the current
mobile unit. All previously “teached” mobile units are
deleted.
NOTE ON THE Add DISPLAY
The Add function can be used to teach up to 4 mobile
units to one stationary unit; but only one mobile unit
can make contact with the stationary unit.
To Next Page
Loading...
Need help?
General
