Eberspächer EasyStart Timer - VENTILATION OFF

VEHICLE HEATERS – TECHNICAL DOCUMENTATION | 15
4 WHAT TO DO IF …?
POSSIBLE DISPLAYS IN THE EVENT OF A FAULT:
DISPLAYS DESCRIPTION REMEDY / WORKSHOP
INIT
 Automatic detection is active.
 The timer has been discon-
nected from the voltage and
reconnected.
Wait until the automatic detec-
tion has ended, then set the
time and weekday.
06 : 00
 The timer has been discon-
nected from the voltage and
reconnected.
 The automatic detection has
ended.
Set the time (hours and min-
utes) and the weekday. Then
the Start display appears.
NO SIGNAL
 No communication.  Check and if necessary
renew the heater fuse.
 Check the voltage supply.
 Check the wiring.
Error
 1st heater fault. Perform the heater
diagnosis.
Error
 2nd heater fault. Perform the heater
diagnosis.