Eberspächer EasyStart Timer User Manual

VEHICLE HEATERS – TECHNICAL DOCUMENTATION | 11
3 OPERATION AND SETTING/ADJUSTMENT
HEATING ON WITH SHORTPRESS AND WITH
SETTINGS
Display ON, the Start display appears.
17:30
21 °C
Press the SHORTPRESS button for less than
2 seconds.
PLEASE NOTE!
The following settings and confirmations (tempera-
ture setpoint and operating time) are always required.
SET TEMPERATURE SETPOINT – FOR AIR HEATERS
ONLY
If applicable, use the
or button to set the
temperature setpoint.
Temperature setpoint setting range:
8 °C – 36 °C in 1 °C increments,
46 °F – 97 °F in 1 °F increments.

21 °C

08:30
120 min
Press the button to confirm the temperature
setpoint.
SETTING THE OPERATING TIME
If necessary, use the
or button to set the
operating time.
Operating time setting range:
Min 10 – max 120 min in 1 min. increments, continu-
ous heating mode is possible for air heaters.
60 min
Press the button to confirm the operating time.
Heater ON.
60 min
21 °C
Display for air heaters in continuous heating mode
(factory setting).
21 °C
∞
PLEASE NOTE!
After switching on, “On” is displayed for 2 sec and
then the remaining operating time or
for air
heaters.
During heating mode it is possible to switch to another
menu item. Under the VENTILATION menu item, check
the operating time and if necessary adjust.
The changed operating time is offered again the next
time the system is started.

Eberspächer EasyStart Timer Specifications

General

Brand	Eberspächer
Model	EasyStart Timer
Category	Control Unit
Language	English