23
7.2.2.12. Operations -> Restore default settings
If operation “Read” finishes with error message (e.g. if access code is unknown) it is
possible to come back to default settings by selecting “Restore default settings”. On
the screen the will appear following message “Do you want to overwrite current
configuration with default values?” After confirming the following window shall appear:
This operation is possible only with local connection. After operation completing device
parameters shall come back to default settings.
7.2.2.13. Help -> About program
Select this function to view additional information about program.
7.2.3. Programmable parameters
Parameters available in configuration program are divided into three groups: Access,
Transmission, Device parameters, Monitoring, Restrictions, Notifications, Link control
and Firmware. Each of these groups will be described in detail in next part of this
manual.
To Next Page
Loading...