Ebyte E18 Series

To Next Page

To Previous Page

Chengdu Ebyte Electronic Technology Co,;Ltd

AN2022001

Chengdu Ebyte Electronic Technology Co,;Ltd

Step 1 Hardware preparation .................................................................................. 3

Step 2 Install tools and drivers .................................................................................. 3

Step 3 Connect debugger/programmer to target module/test kit ........................................................3

Step 4 Connect USB cable .................................................................................... 4

Step 5 Associate a USB device with a USB driver .................................................................. 4

Step 6 Check LED status ...................................................................................... 4

Step 7 Flash firmware .........................................................................................5

Revision history ............................................................................................. 6

Ebyte E18 Series - Page 2