Ebyte E32 Series - Module Is Easy to Damage; Ber(Bit Error Rate) Is High

Chengdu Ebyte Electronic Technology Co.,Ltd. E32-900M30SA User Manual
Copyright ©2012–2021，Chengdu Ebyte Electronic Technology Co.,Ltd.
10
6.2 Module is easy to damage
 Please check the power supply source, ensure it is 2.0V~3.6V, voltage higher than 3.6V will damage the module;
 Please check the stability of power source, the voltage cannot fluctuate too much;
 Please make sure antistatic measure are taken when installing and using, high frequency devices have electrostatic
susceptibility;
 Please ensure the humidity is within limited range, some parts are sensitive to humidity;
 Please avoid using modules under too high or too low temperature.
6.3 BER(Bit Error Rate) is high
 There are co-channel signal interference nearby, please be away from interference sources or modify
frequency and channel to avoid interference;
 SPI clock waveform is not standard, check whether there is interference on the SPI line, SPI bus wiring should
not be too long;
 Poor power supply may cause messy code. Make sure that the power supply is reliable;
 The extension line and feeder quality are poor or too long, so the bit error rate is high.