Ebyte E52-400/900NW22S - More Setting Commands

Chengdu Ebyte Electronic Technology Co.,Ltd.. E52-400/900NW22S User Manual
CopyriCopyright ©2012–2023, Chengdu Ebyte Electronic Technology Co.,Ltd.
14
AT+MEMBER_RAD=<rad>,<save>
Set module multicast
member radius
For multicast use, it is recommended to
keep the default
<rad>: multicast member radius (0 ~ 15)
<save>: whether to save to Flash
AT+NONMEMBER_RAD=<rad>,<save>
Set module multicast
non-member radius
For multicast use, it is recommended to
keep the default
<rad>: Multicast non-member radius (0 ~
15)
<save>: whether to save to Flas
AT+CSMA_RNG=<rng>
Set CSMA random
avoidance time
it is recommended to keep the default
Random avoidance time range (20 ~ 65535)
ms
AT+ROUTER_SCORE=<score>
Set the maximum
number of consecutive
routing failures
<score>: The maximum number of
consecutive route failures,
Routes need to be re-established after
exceeding
AT+HEAD=<enable>
Set the extra frame
header function enable
switch
<enable>: Whether the extra frame header
function is enabled
AT+SECURITY=<enable>
Set the data encryption
function enable switch
<enable>: Whether the data encryption
function is enabled
AT+RESET_AUX=<enable>
Set auto-reset LED2
change switch
<enable>: Automatic reset LED2 change
enable
AT+RESET_TIME=<reset_time>
Set automatic reset time
<reset_time>: automatic reset interval time
(min)
AT+FILTER_TIME=<time>
Set broadcast filter
timeout
it is recommended to keep the default
<time>: Broadcast filter timeout (3000 ~
65535 ms)
AT+ACK_TIME=<time>
Set request response
timeout
it is recommended to keep the default
<time>: Request response timeout (1000 ~
65535 ms)
AT+ROUTER_TIME=<time>
Set routing request
timeout
it is recommended to keep the default
<time>: Routing request timeout (1000 ~
65535 ms)
AT+GROUP_ADD=<gruop>
Add GROUP
information
<group>: Add multicast group address, up
to 8 can be added
AT+GROUP_DEL=<gruop>
Delete GROUP
information
<group>: Delete multicast group address
AT+GROUP_CLR=<enable>
Delete GROUP
information table
<enable>: 1: Delete the entire GROUP
information table
AT+ROUTER_CLR=<enable>
Clear routing table
information
<enable>: 1: Delete the entire routing
information table