Copyright©2012–2023, Chengdu Ebyte Electronic Technology Co., Ltd.
17
Arrow 18: Set the serial number of the polling command
Arrow 19: Turn on or off a command enable
Arrow 20: Set the response timeout of this command (200-3000ms)
Arrow 21: Set the waiting time from executing the entire polling cycle to the next polling cycle (3000-50000ms)
Arrow 22: Enter the specific command to be polled in the input box
Arrow 23: Click to add instructions to the buffer
Arrow 24: Select the instruction in the buffer area and click to modify the instruction to synchronize the parameters
to the setting area
Arrow 25: Set the number of command sending
Arrow 26: Select the buffer command and click the delete command to delete it
Arrow 27: Click to read the existing instructions of the device into the cache area
Arrow 28: Click to write the buffer instruction to the device
Arrow 30: Click to delete device directive
To Next Page
Loading...
