Chengdu Ebyte Electronic Technology Co,.Ltd E810-DTU User Manual
Copyright ©2012–2020, Chengdu Ebyte Electronic Technology Co,.Ltd
Figure 13 RF Parameter configuration settings
(2) Open two network debugging assistants, set the network debugging assistant protocol type to TCP Client, the
network debugging assistant's server IP address is set to the module's IP address, the network debugging assistant's server
port is set to the module's local port, click Connect.
(3) Enter a string of data in the sending area of network debugging assistant A, click Send, you will see that network
assistant B has received the same data in the sending area of the serial port. Input a string of data in the sending area of
network debugging assistant A, network assistant B also received the data. It realizes bidirectional transparent
transmission.
To Next Page
Loading...
Need help?
General
