Chengdu Ebyte Electronic Technology Co., Ltd. E90-DTU(400SL30P)User manual
Copyright ©2012–2019, Chengdu Ebyte Electronic Technology Co., Ltd
When users use the host computer to configure the relay mode, they need to pay special attention. Because each
parameter in the host computer is a decimal display mode, the module address and network ID need to be converted
when filling in. For example, if the network ID entered by the transmitting end A is 02 and the network ID entered by the
receiving end B is 10, when the relay end R sets the module address, it will convert the hexadecimal value 0X020A to a
decimal value 522 as the relay end R to fill Module address. That is, the module address value to be filled in by the relay
rat this time is 522.
To Next Page
Loading...
Need help?
General
