EC-80320 User’s Manual
- 34 -
ESC - Turn underline mode on/off
Format: ASCII: ESC - n
Decimal: 27 45 n
Hex: 1B 2D n
Description:
n=0, 48 Turn underline mode off.
n=1, 49 one-dot thick underline mode on
n=2, 50 two-dot thick underline mode on
ESC 2 Set default line spacing
Format: ASCII: ESC 2
Decimal: 27 50
Hex: 1B 32
Description:
Set the line spacing to 1/6 inch.
ESC 3 Set line spacing as n/203 inch
Format: ASCII: ESC 3 n
Decimal: 27 51 n
Hex: 1B 33 n
Description:
Set the line spacing to n*(vertical or horizontal motion unit) n=0～255.
The vertical or horizontal motion units are specified by GS P Command.
ESC = Select peripheral device
Format: ASCII: ESC = n
Decimal: 27 61 n
Hex: 1B 3D n
Description:
The Last bit of n is 0, printer disable.
The Last bit of n is 1, printer enable.
ESC ? Cancel user-define character
Format: ASCII: ESC ? n
Decimal: 27 63 n
Hex: 1B 3F n
Description:
Cancel the character specified by n. n=32~126.
ESC @ Initialize printer
Format: ASCII: ESC @
Decimal: 27 64
Hex: 1B 40
Description:
Initialize the printer to the state when the printer was turn on.
To Next Page
Loading...