ECD DO82 Instructional Manual

HYDRA-DS NO
3
-N Page 36
7.0 ENGINEERING DOCUMENTATION
7.1 SPECIFICATIONS
7.1.1 SENSOR
Three Electrode system with spray cleaner, Nitrate ISE (NO3-N) is the primary measurement. The Chloride ISE is used
to compensate the NO3 signal. An optional pH electrode is available for pH measurement. The Sensor is waterproof
with an ingress rating of IP 68.
Measurement Range
NO
3
-N: 0.1 to 1000 ppm
Operating Temperature
0°C to 40°C (32°F to 104°F)
Min/Max Flow Rate
Minimum 0.1 m/s
Maximum 3.0 m/s
Wetted Materials
PVC, PES, PVDF, PTFE, Viton, Glass, 316 SS
Accuracy
± 3% of reading, dependent on Calibration
Response Time
T90 1 minute
Electrode Life
ISEs: 4-6 months, typical
pH electrode: 6-12 months, typical
7.1.2 T80 TRANSMITTER
7.1.2.1 INPUT SPECIFICATION
 Digital protocol, all ECD S80 sensors
 Optional analog to digital converter, 5 inputs [mV+, mV-, solution ground, temp + temp – (100 K-ohm)]
7.1.2.2 INPUT RANGES
pH
-1.00 – 15.00 pH
ORP
-1500 – +1500 mV
pION
000.1 – 999.9, Auto Ranging: ppb ↔ ppm ↔ ppT (thousand)
Dissolved Oxygen
000.1 – 999.9, Auto Ranging: ppb ↔ 20.00 ppm, % SAT, mg/L
Conductivity
0.000 – 2.000, Auto Ranging: µS ↔ mS ↔ S
TDS 0.00 – 9999ppm
Resistivity
0.00 – 50.00 MΩ
Turbidity
0 – 4000 NTU/FNU, 0 – 9999 ppm, mg/l, 0 – 100% % solids
Temperature
100 K-ohm TC, -30°C – 140°C

ECD DO82 Specifications

General

Brand	ECD
Model	DO82
Category	Transmitter
Language	English