ECG EDF 4516 QA+ - ADDITION OF SALT TO WATER SOFTENER

GB
55
• The appliance is equipped with aspecial water softener using salt dispenser designed to remove calcium
and other minerals from the water.
ADDITION OF SALT TO WATER SOFTENER
The salt dispenser is located under the bottom basket. Fill it according to the following description:
• Use only salt designed for dishwashers! Other types of salts, which are not intended for dishwashers, for
example kitchen salt would damage the water softener. In case of damage caused by use of improper salt
the manufacturer does not keep warranty and is not responsible for any damage.
• Replenish salt just before starting one of the complete washing programs. You will prevent corrosion due
to left over salt crystals or over owed solution on the bottom of the dishwasher.
1
2
A. Remove the bottom basket and then unscrew the lid of the salt dispenser 1.
B. If you  ll the dispenser for the  rst time,  ll to 2/3 of the volume with water (about 500 ml) 2.
C. Insert afunnel (supplied) into the opening of the dispenser and pour into it about 1.2kg of salt. Asmall
amount of water usually over ows from the dispenser.
D. Screw the lid back properly after  lling the dispenser.
E. Usually within 2–6 days after  lling the salt container the salt indicator light goes o .
Note:
1. Salt should be added when on the control panel the salt indicator lights up. Before the salt fully dissolves,
the salt indicator is lit even after the salt has been replenished.
2. If you spill salt around the container, start the soaking / rinsing program, which removes salt.
FILLING THE RINSE AID DISPENSER
The rinse aid function
Rinse aid is automatically dispensed for the  nal polishing process and prevents spotting and streaking during
drying.
WARNING
Use only brand name rinse aids for the dishwasher. Never  ll the rinse aid dispenser with any other substances
(e.g. dishwasher detergent, liquid detergent). The dishwasher could be damaged.