ECG EDF 4516 QA+ - TECHNICAL SPECIFICATIONS

GB
69
TECHNICAL SPECIFICATIONS
Speci cations for the household dishwasher according to EU regulations no. 1059/2010:
Manufacturer ECG
Model EDF 4516 QA+
Number of dish sets 9
Energy e ciency class
1
A+
Annual energy consumption
2
222 kWh
Energy consumption per standard wash cycle 0.76 kWh
Energy consumption in o mode 0.35 W
Energy consumption in standby mode 0.9 W
Annual water consumption
3
2800 l
Drying e ciency class
4
A
Standard wash cycle
5
Eco
The length of program of the standard wash cycle 168 min
Noise level 49 dB(A)
Assembly Freestanding
Height 845 mm
Width 448 mm
Depth (including connections) 600 mm
Power input 1850 W
Rated voltage / frequency 220–240 Vac / 50 Hz
Water pressure (hydrodynamic pressure) 0,4-10.0 bar = 0,04-1.0 MPa
Water temperature Max. 65 °C
Note:
1 A + + + (highest e ectiveness) up to D(lowest e ectiveness)
2 The annual consumption of energy 222 kWh is calculated on the basis of 280 standard wash cycles using cold water and
programs with lower energy consumption. Actual energy consumption will depend on how the appliance is used.
3 The annual consumption of water 2800 litres is calculated on the basis of 280 standard wash cycles. Actual water
consumption will depend on how the appliance is used.
4 A (highest e ectiveness) up to G(lowest e ectiveness)
5 This program is suitable for washing normally soiled dishes and in the same time the program is the most e cient in
terms of energy and water consumption for that category of dishes.
The appliance meets European standards and regulations in their current version:
– LVD 2006/95/EC
– EMC2004/108/EC
– EUP 2009/1016
The above values were measured under speci c conditions, in accordance with the relevant standards. Results may vary
signi cantly depending on the amount and degree of soiling of the dishes, water hardness, amount of detergent, etc.
This instruction manual is written according to the standards and regulations of the European Union.